![]() + - replicated route, % - next hop overrideġ0.0.0.0/8 is variably subnetted, 2 subnets, 2 masksĬ 10.1.1.0/24 is directly connected, FastEthernet0/0 O - ODR, P - periodic downloaded ST route, H - NHRP, l - LISP Ia - IS-IS inter area, * - candidate default, U - per-user ST route I - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2 N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2Į1 - OSPF external type 1, E2 - OSPF external type 2 R1#conf tĮnter configuration commands, one per line. Use the following commands to add a static route for R1. Now, you need to add ST Route on Router R1 and R2 to communicate virtual machines. The reason for this because no routing protocols configured, Windows 8 cannot access the Serial interface of Router R2.ĭo the same on the Windows 10 machine and observe that the ping failed for the 192.168.5.0/24 network. Pinging from Windows 8 to the Fa0/2 interface of Router R2 will also fail as follows. This is where the importance of ST Route or dynamic protocols emerges. R2(config-if)# ip address 10.1.1.2 255.255.255.0īefore you configure Static Route, this will fail when you ping the Fa0/0 interface of Router R2 from Windows 8. In the same way, configure the Fa0/0 interface of Router R2. Pinging from the Windows 10 machine to the Fa0/1 interface of Router R2 will also be successful.Ĭonfigure the FastEthernet0/0 interface of the Cisco Router R1. When pinging the Fa0/1 interface of the Cisco Router R1 from the Windows 8 machine, and you will see that the connection was successful. In the same way, configure the interface to which the 192.168.10.0/24 network connected to the Cisco Router R2. Check your configured interfaces with the show ip interface brief command. Open the Cisco Router R1 CLI prompt and configure the FastEthernet 0/1 interface. In the same way, configure the IP address of the Windows 10 virtual machine on VMware Workstation as follows. You can also provide a clearer understanding of the network topology by adding comments.Ĭonfigure the IP address settings of the Windows 8.1 virtual machine on VMware Workstation as follows. In the GNS3 program, create a network topology as shown in the image below. Open the GNS3 program for Static Route and create a new project.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |